loading
reading
writing
saving
searching
CAM Thermoformer - $25,000 (North Little Rock)
QR Code Link to This Post
Does not power on.
Forming Area (platen size): 42-1/4" wide x 72" deep (both sides)
Maximum sheet size accepted: 80" x 80"
Heater Surface Area: 96-1/2" x 96-1/2"
Machine Dimensions (overall footprint): 303-1/2" long x 154" wide x 108-1/2" tall (excluding tank)
Electrical Requirements: 480V/3Ph/60Hz, unknown Amps.
Compressed Air Requirements: Operated at 125-135 psi without issue
Heater Type: Open coil with ceramic fiber foam insulation
Number of Heating Zones: 8 upper heat zones
Zone Controls: Individual timers
Pre-Stretch / Bubbling Capability: Yes (see Function Test below)
Vacuum System: NOT included
Vacuum/Holding Tanks: one tank, ~62ft.3 (4ft. dia. x 5ft. L)
Cooling System: Three fans Side A, two fans Side B
Clamping System: Pneumatic, top load both ends
Total Operating Hours: 39,982.4 total hours
Overall Physical Condition: Good
PLC Condition: Poor
Function Test: Cannot check, bad PLC power supply that went out when turning off 480V breaker. Replacing has potential to wipe programming; which is proprietary. Backups available but unknown state.
Included Accessories: Pneumatic clamp cylinders and o-rings for them; as well as various sized clamp inserts and shims available.
Last operated 2022.
Price listed is for item(s) stated. Items in background of picture available for purchase, a post may already exist but feel free to inquire.